Center Marking Punch and Die Sets

Center Marking Punch and Die Sets—28XX™, 36TC™ and 44TC™—are used for marking center points in work requiring secondary operations such as drilling. They are also used to locate points for bend or shear lines or to check for correct punch locations.

Punches and dies can be used individually to mark either the top or the bottom of the material, or to simultaneously mark both surfaces.

When marking the top side of the material only, a flat "anvil" die is used with the marking punch. When marking the bottom side of the material only, a flat "anvil" punch is used with the marking die. The pressure switch cycle control on the hydraulic press is used to limit the marking force.

28XX Center Marking punches and dies feature replaceable center points.

36TC and 44TC Center Marking Sets feature replaceable Center Marking Inserts.