Trim and Part Punch and Die Sets

28XX™ Style Tooling. For manual presses only.

This tooling set is for use in mild steel only. It does not require any special holders or adapters and can be easily installed in the quick change punch adapter and die shoe. Two guides locate the work piece centrally in the the die and punch guide heels enter the die before the punch begins to cut, thus assuring perfect alignment. It is possible to trim off the ends of strips without shifting the punch out of alignment.

When ordering, please specify for 16 ga. through 5/32" or 3/16" through 1/4" material.

Hold-down straps are furnished only on dies for 3/16" through 1/4" material.

Maximum Material Capacity: 1/4" Mild Steel